12/16/2008
Click on a thumbnail to see the full-size image
Adjusting the Fuel Pressure on GM's Electronic Fuel Injection
In
this article we will discuss how to properly adjust the fuel pressure
on a GM fuel injected engine and how to gain the most power through the
adjustment. By adjusting the fuel pressure you are looking for maximum
power from your new high performance engine and this will take some
trial and error to achieve.
In order to make the adjustment you will need the following tools: A
fuel pressure gauge that will screw onto your Schrader Valve on your
fuel rail and a small wrench to turn the screw on the regulator.
Step #1 - You
will need to screw the fuel pressure gauge onto the Schrader Valve that
is located on your fuel rail, (see photo 1) make sure that it is
tight to avoid any leaks and or fires. Once the gauge is installed turn
the ignition key to the on position and check for leaks at the Schrader
Valve.
Step #2 - Start
the engine and let the idle level off and then disconnect the vacuum
line that goes to the regulator (see photo 2), make sure that you
plug the rubber vacuum line so it does not leak vacuum while you are
making the adjustment, (you only care about the fuel pressure reading with the vacuum line disconnected at idle).
Step #3 - Take the reading and make the adjustment to 46 lbs (see photo 3).
Step #4 - You
will need to drive the vehicle and take notes as to how it is
performing, I recommend driving it for a little while so you know
exactly how the engine and vehicle react. Once you are familiar with
the engines performance adjust the fuel pressure up 2 lbs. at a time
taking notes as to the performance gain or loss and finally end your
adjustment at max power.
This tech tip is from Chad Golen, Golen Engine Service
Additional Tech Tips>>