5/12/2009
Click on a thumbnail to see the full-size image
Figure 1
|
Ford 2.3/2.0L Duratec Needs Special Tools To Install Crankshaft Pulley - Possible No Start Issues
Some 2001-2007 vehicles equipped with a Ford 2.0L or 2.3L Duratec Engine may exhibit no start, loss of engine timing or scraping noise at crankshaft pulley at front of engine. These engines, (excludes 2.0L SPi and Zetec engines) may experience engine damage if the crankshaft pulley bolt is loosened during service WITHOUT FIRST INSTALLING THE SPECIAL SERVICE TOOLS.
The crankshaft pulley bolt also retains the crankshaft cam drive sprocket which is NOT keyed to the crankshaft, so valve timing may shift if the crankshaft pulley bolt is loosened. If this occurs, the pistons may contact and damage the valves.
Before ANY repair that requires loosening or removal of the crankshaft pulley bolt, engine valve timing MUST be locked by using the Special Service Tools. Do not attempt to start the engine without verifying engine cam timing.
SERVICE TOOLS REQUIRED:
1) Crankshaft Timing Peg ESST Number 303-507 is 2-1/8" (54 mm).
2) Camshaft Alignment Plate ESST Number 303-465.
3) Holding Fixture ESST Number 205-126.
4) Adaptor 205-072-02.
Inspect the crankshaft pulley for rubber protruding from the pulley (Figure 1), loose pulse wheel, or bent tabs on pulse wheel touching engine front cover. Replace crankshaft puiiey with service kit for respective vehicle line.
Some or all of this information was provided by the Automotive
Parts Remanufacturers Association (APRA). For more information on
technical bulletins available through APRA call 703-968-2772 or visit www.AutoBulletins.com.