Click on a thumbnail to see the full-size image
Honda J35 V6 Engine Knocks or Ticks at Idle
The problem affects some 2008-2010 Honda vehicles with the J35 V6 engine.
Symptom: The engine knocks or ticks at idle. The noise is usually more noticeable when the engine is warm.
Probable Cause: The rocker shaft bridge has excessive clearance, which causes the rocker shaft to rotate and make noise.
Flange Bolt (Use only if a bridge bolt fails): P/N 95801-08060-08
Intake Manifold Cover Gasket: P/N 17146-R70-A01
Intake Manifold Gasket (Pilot 4WD, Accord): P/N 17105-RCJ-A01
Intake Manifold Gasket (Pilot 2WD, Odyssey): P/N 17105-RCA-A01
Diagnosis: While the engine is idling, listen for a knock or tick. Use a stethoscope to find the location of the noise. If you hear knocking or ticking from either cylinder head, go to Repair Procedure. If you hear a noise coming from another location, continue with normal troubleshooting.
1. Remove both cylinder head covers: Refer to Cylinder Head Cover Removal in Section 6 of the appropriate service manual; or Online, enter keywords COVER REM, then select the appropriate Cylinder Head Cover Removal procedure from the list. Note: To ease removal of the cylinder head cover, remove the power steering pump with its hoses connected. This allows access to the wire harness mounting bolts. See Fig. 1.
2. Starting with the front cylinder head, loosen and then torque each rocker shaft bridge bolt in the sequence shown in Fig. 2. Torque bridge bolts 1 through 8 to 19 lb.-ft. (26 Nm). Torque bridge bolts 9 and 10 to 18 lb.-ft. (24 Nm).
Note: The bridge is designed to crush around the rocker shaft, so when torquing the bolts it may initially feel like the bolt is stripped. This is normal; continue torquing bolts until the appropriate torque value is reached. Do not replace the bolt, the bridge or the head. Do not over-torque the bolts. If you do, they may break and will need to be replaced. The bridge bolts for VCM and V-TEC engines have the same torque values and tightening sequences. Only VCM cylinder heads are shown in the illustrations.
3. Repeat Step 2 on the rear cylinder head. See Fig. 3.
4. Check the valve clearances, and adjust them if needed: Refer to Valve Clearance Adjustment in Section 6 of the appropriate service manual; or Online, enter keywords VALVE CLEAR, and select the appropriate Valve Clearance Adjustment procedure from the list.
5. Reinstall the cylinder head covers: Refer to Cylinder Head Cover Installation in Section 6 of the appropriate service manual; or Online, enter keyword COVER INS, then select the appropriate Cylinder Head Cover Installation procedure from the list.
6. Reinstall all removed parts.
7. Start the engine, and let it reach normal operating temperature. Make sure the noise is gone.
Courtesy of ALLDATA.