Detonation and pre-ignition
The Chevrolet LT engine family from General Motors is rooted in the early ‘70s, when the LT1 was featured in the Corvette and Camaro Z28. After a 20-year hiatus, GM reintroduced the platform in the early ‘90s. The “LT1 350” came out in 1991, and was distinct from the high-output Gen I LT1 of the 1970s. It displaced 5.7L (350 cu in), and was a two-valve per cylinder pushrod design. The LT1 used a reverse-flow cooling system, which cooled the cylinder heads first, maintaining lower combustion chamber temperatures and allowing the engine to run at a higher compression than its immediate predecessors.
Lead times are no longer months upon months as they were in the middle of 2020 and throughout 2021, but the situation is still of some concern, and it’s forced engine builders to get creative at times.
LS swaps are popular for many reasons, but there are a lot of variations and details to sort through – more of them than you may expect – and many of them are associated with the intake manifold.
Whether you’re scouring junkyards, ordering cores, investigating factory options, looking at aftermarket cast iron or aluminum blocks, or spending big bucks on billet LS blocks, you’ve probably noticed it’s been harder to find exactly what you want for the foundation of your LS build than it historically has.
Closed-loop control can be programmed to either add or subtract up to a certain percentage of fuel in order for the engine to reach the target air/fuel ratio.
Despite not being a fancy, state-of-the-art set up, Mike and his team at H&H have a great thing going. The equipment does exactly what it needs to, his team is experienced and the shop has built thousands of vintage engines for customers everywhere!
This shop’s dedication to quality engine work, its growth, its machining capabilities and its impact in the diesel industry, all make Choate Engineering Performance well deserving of Engine Builder’s and Autolite’s 2022 America’s Best Diesel Engine Shop award.
The 4 Piston Racing facility in Danville, IN houses two buildings – one is 12,000 sq.-ft. and the other is 2,500 sq.-ft. The shop is very heavily focused on Honda cylinder heads and engine work to the tune of 300+ engines and 1,000 cylinder heads annually!