Oil Drain Intervals - Engine Builder Magazine

Oil Drain Intervals

One of the great debates in automotive service is oil drain intervals. The correct oil change interval is the one prescribed by the engine manufacturer that can be found in a vehicle owner’s manual. Oil drain interval is determined by the engine type, drive train, vehicle type and expected use. Each OEM tests its own vehicles to determine the proper drain interval.
Some OEMs may have changed to longer drain recommendations as engines and motor oils are far more advanced over those produced even a few years ago. However, this is not always true, so you should check the owner’s manual for the specific drain interval for every vehicle.

Understanding the type of driving a customer does with their vehicle is also beneficial. Generally speaking, most consumers drive a severe cycle of short trip or stop-and-go type service and using the severe service drain interval is recommended.

With summer here and travel increasing, people that use their car, SUV or light duty truck for towing should also follow recommendations for severe service.

There is not a downside to more frequent oil changes. A shorter drain will provide the best defense against harmful engine deposits, better oil consumption control, improved fuel economy and lower wear on engine parts. More frequent oil changes may also help vehicle owners discover a more serious engine problem such as a coolant leak before serious damage occurs.

Engine deposits and wear are slow, sure killers of performance and engine life. In most cases, by the time owners are aware of an issue, the damage has been done and often cannot be reversed without an engine rebuild. Changing the oil in a vehicle at the appropriate drain interval is the easiest, most cost effective insurance against lubricant-related engine damage.

– Provided by Pennzoil

You May Also Like

LTR Engine Build

This Late Model Engines build is centered around Concept Performance’s new LTR block, which is the first aftermarket as-cast aluminum Gen V LT block. 

The Chevrolet LT engine family from General Motors is rooted in the early ‘70s, when the LT1 was featured in the Corvette and Camaro Z28. After a 20-year hiatus, GM reintroduced the platform in the early ‘90s. The “LT1 350” came out in 1991, and was distinct from the high-output Gen I LT1 of the 1970s. It displaced 5.7L (350 cu in), and was a two-valve per cylinder pushrod design. The LT1 used a reverse-flow cooling system, which cooled the cylinder heads first, maintaining lower combustion chamber temperatures and allowing the engine to run at a higher compression than its immediate predecessors.

LS Intake Manifolds

LS swaps are popular for many reasons, but there are a lot of variations and details to sort through – more of them than you may expect – and many of them are associated with the intake manifold.

LS Cylinder Heads

The LS engine is known for its cylinder heads, and there are tons of options available to upgrade the factory components.

Choosing the Correct Block for Your LS Engine Build

Whether you’re scouring junkyards, ordering cores, investigating factory options, looking at aftermarket cast iron or aluminum blocks, or spending big bucks on billet LS blocks, you’ve probably noticed it’s been harder to find exactly what you want for the foundation of your LS build than it historically has.

Open Loop/Closed Loop and Learning

Closed-loop control can be programmed to either add or subtract up to a certain percentage of fuel in order for the engine to reach the target air/fuel ratio.

Other Posts

Shop Solutions January 2023

Next time you have set of large journal small block Chevy connecting rods to resize, consider honing the big ends of them for a +.002” outside diameter bearing that the LS engines with fracture cap rods use.

Shop Solutions December 2022

Everyone misses occasionally, and this helps avoid dents and damage.

Jesel Certified Performance Rebuilds

Engine components are serious investments for any racer and maintaining that investment could be the difference between winning a championship and losing it.

Going the Extra Mile with Cylinder Head Porting

It’s not just the port work alone that creates spectacular cylinder head performance. The most critical areas of a cylinder head are those which pass the most air at the highest speed and for the longest duration. Your bowl area, the valve job, the throat diameter, and combustion chamber are all crucial parts.