Valve Train Ticking Noises Reported on Honda 2.2L Engines - Engine Builder Magazine

Valve Train Ticking Noises Reported on Honda 2.2L Engines

A probable cause for this condition is the intake rocker shaft
clearance is excessive at the number two cylinder. To correct this
condition, adjust the valve clearances or replace the cam holder and
the adjoining intake rocker arm shafts at the number two cylinder.

Repair Procedure:

1) Measure the intake valve clearance at the number two cylinder intake valve closest to cylinder number one (Figure 1). If the clearance is more than .040 mm, replace the cam holder. If the clearance is less than .040 mm, go to next step.

2) Adjust the valve clearance (Figure 2). If no adjustment screw threads are visible above the locknut, replace the cam holder.

Some or all of this information was provided by the Automotive
Parts Remanufacturers Association (APRA). For more information on
technical bulletins available through APRA call 703-968-2772 or visit www.AutoBulletins.com.
Figure 1Figure 2

You May Also Like

Shop Solutions March 2024

I always keep a pair of needle nose pliers and a small, straight screwdriver in my blast cabinet to hold small parts when blasting.

Engine Builder and Engine Pro present Shop Solutions in each issue of Engine Builder Magazine and at enginebuildermag.com to provide machine shop owners and engine technicians the opportunity to share their knowledge to benefit the entire industry and their own shops. Those who submit Shop Solutions that are published are awarded a prepaid $100 Visa gift card. Submit your Shop Solution at [email protected]. You must include your name, shop name, shop address and shop telephone number. Submitted Shop Solutions not published will be kept on file and reevaluated for each month’s new entries.

Degreeing the Camshaft and Checking Valve-to-Piston Clearance

Jeff McCord of LinCo Diesel Performance walks you through degreeing a camshaft and checking valve-to-piston clearance.

Designing a Better LS Engine

After a customer wanted a Steve Morris Engines’ SMX in an LS version, Steve saw the upside and potential in the market, and a challenge to build a better LS.

The Importance of a Good Valve Job

The valve job ensures the mating surfaces of the valves and the seats properly control the air/fuel mixture.

Other Posts

Getting Better Cylinder Head Airflow

When it comes to improving horsepower and rpm, airflow has a lot to do with it, and it seems the job is one that’s never finished.

Horsepower and Head Gasket Technology

Head gaskets have one of the toughest job in an engine, and now we’re pushing them harder than ever, making it easier to expose the slightest weakness.

Inside the Development of Frankenstein’s F-Series LS Cylinder Heads

Right away, engine builders knew it was special.

Shop Solutions – January 2024

Before installing cam bearings, make sure to chamfer any oil holes and clean up back grooves of any sharp edges.