Removing Crankshaft Pilot Bearings (#3) - Engine Builder Magazine

Removing Crankshaft Pilot Bearings (#3)

Soak the paper in water and stuff it into the hole, and then drive it in with a bolt or other tight fitting tool. Keep cramming in more wet toilet paper until the bearing pops out.  

In my experience, this method is much quicker than using bearing removal tools and is way cleaner than using grease.

 

Arus Kinney

Austin-Jordan Engines

Wyoming, MI

 

You May Also Like

Shop Solutions July 2023

Engine and machine shop tips and tricks.

BOLT COLLET

To precisely shorten bolts in the lathe, I made slotted collets for each bolt diameter. They are fractional in length to measure off the end, so you know where to cut for your length. I’ve used large O.D. valve guides and aluminum round stock. Just make the collet big enough to clear the bolt flange, hex or socket head.

Shop Solutions June 2023

Engine and machine shop tips and tricks.

May Shop Solutions 2023

Engine and machine shop tips and tricks.

April Shop Solutions 2023

Engine and machine shop tips and tricks.

Shop Solutions March 2023

If I’m not using torque plates, I tape up both sides and trim out the bores. I use painter’s tape, which comes off easily and doesn’t leave any glue residue. I get much less oil in the spray washer this way.

Other Posts

Shop Solutions February 2023

Check out February’s shop tips and tricks.

Shop Solutions January 2023

Next time you have set of large journal small block Chevy connecting rods to resize, consider honing the big ends of them for a +.002” outside diameter bearing that the LS engines with fracture cap rods use.

Shop Solutions December 2022

Everyone misses occasionally, and this helps avoid dents and damage.

November 2022 Shop Solutions

November tricks and tips for the shop!