Banks Ram-Air Intake Systems for 2020-22 Duramax 6.6L - Engine Builder Magazine

Banks Ram-Air Intake Systems for 2020-22 Duramax 6.6L

This Banks air intake system offers a variety of improvements for your 2020-22 Duramax 6.6L.

The new Banks Ram-Air intake system for the 2020-22 Duramax 6.6L is now available for pre-order! The innovative cold air intake adds power, sharpens turbo response, and improves fuel economy.

The greater the air mass, the easier it is for your engine to make the same horsepower while using less fuel. In other words, fuel economy! Yes, airflow (CFM) is important, but if the system flows more air, and that air is hot, you’ll likely see a loss in horsepower. Pressurized, cool, dense air is the winning combination. To learn more about air density, see this article.

The ECM (engine control module) in your 2020-22 Duramax monitors air mass and pressure so closely that any deviation from stock results in a check engine light. This means that competitive aftermarket intakes must flow the same as stock. The new patented Banks Air Mass Control Module allows our engineers to design past this electronic limitation. In other words, we are not limited by stock airflow constraints. U.S. Patent #11,193,441

You May Also Like

CP-Carrillo Pistons and Rods for VW/Audi

This piston and rod combination is designed as a perfect fit and meant to withstand large boost levels.

CP-Carrillo offers #SC7630 pistons and rods for the Volkswagen/Audi EA888 Gen III 2.0L TSI/TFSI engine. This engine is in numerous applications, including the VW Golf Mk7 R, Audi S3 and Audi TTS vehicles.

This piston and rod combination is designed as a perfect fit and meant to withstand large boost levels to take your engine to the next level. The pistons are made to accept 1mm larger valves, as well as deeper valve pockets to accommodate many aftermarket cams.

Eneos Racing Pro 10w-50 Oil

With Racing Pro 10w-50, a 50/50 ester mix provides exceptional wear protection, extra high horsepower, and further anti-oxidation stability.

Eneos 10w-50 motor oil
Fluidampr Performance Damper for Mazda Miata

Fluidampr performance dampers protect your engine from destructive crankshaft torsional vibration.

Fluidampr Mazda Miata damper
Mahle PowerPak Pistons for 6.0L and 6.4L Powerstroke Engines

All four sets offer incredible versatility, allowing a daily driver to become a weekend warrior for drag, dyno, or pulling competitions.

Point One Small Block Chevy Head Stud Kit

Point One’s E190 head studs boast an impressive 190,000 psi nominal tensile strength.

Cadillac Supercharged LS engine

Other Posts

Paul Vasko’s LML Duramax-Powered Diesel Dragster

During our weekend at the 2023 Ultimate Callout Challenge, there were plenty of fun conversations, but speaking with drag racer Paul Vasko was definitely a highlight. His passion is contagious, and his diesel dragster is definitely badass, thanks in part to a turbocharged LML Duramax engine. It’s our Diesel of the Week brought to you

Paul Vasko LML Duramax
Weinle Motorsports Sheet Metal Intakes

These custom aluminum sheet metal intakes are built to your specs.

Peterson Fluid Systems’ Fat Boy Dirt Late Model Oil Tank

Peterson Fluid Systems’ new 08-0919 Fat Boy Dirt Late Model Oil Tank provides engine builders with more oil capacity when chassis space is limited. With a lower profile design and all the standard features of their race-proven DLM tanks, this tank is 18.62” tall with a 5-gallon capacity. Related Articles – Total Seal Severe-Duty High-Performance Diesel Rings

Total Seal Severe-Duty High-Performance Diesel Rings

New Total Seal diesel ring sets are available for Cummins 5.9L and 6.7L, Duramax 6.6L, Powerstroke 6.4L to 7.3L, and custom sets.