Moroso Archives - Page 5 of 8 - Engine Builder Magazine
Moroso Multi-Inlet, Compact, Billet Aluminum Breather Tanks

The breather tanks feature internal baffling with mesh media for superior separation of air and oil.

Moroso AJPE TFX 96, TFX2000 & TFX 2002 Oil Pan

This oil pan features an “L” shaped billet aluminum, o-ringed oil pan rail for strength on the track.

Moroso External Oil Pumps

Both external pumps feature a v-band mounting flange to mount to ProCharger supercharger front drives and a 3/8˝ hex fuel pump drive with 1:1 ratio.

Moroso LS Next Gen 3 Race-Baffled Oil Pan

This oil pan is designed to fit 1967-’92 F-Body, 2010-’15 Camaro, 1968-’78 Nova, 1965-’72 Chevelle, 1953-’96 Corvette, 1978-’88 G-Body and GM S10/S15 two-wheel-drive Blazer/truck.

Moroso Ultra 40 Ignition Wire Set for LT Engines

Wire Sets are constructed out of Moroso ULTRA 40, 7mm diameter ignition wire with 40 ohms of resistance per foot.

Moroso External Oil Pumps, Single Stage, Reverse Rotation, V-Band Mounting Flange

External pumps eliminate the camshaft loads that occur with an internal pump and run cooler than internal pumps.

Moroso Ford 5.0L Coyote, 5.2L Voodoo Windage Tray & Oil Pan Gasket

Required when installing a Moroso oil pan and oil pump pickup on a Gen III engine or is a replacement windage tray/oil pan gasket on a Gen I or Gen II engine.

Moroso Dry Sump Pump, Five-Stage Fuel Pump Drive

The pump weighs almost half of gerotor pumps and takes up to 40% less power to drive.

Moroso SB Chevy Valve Covers with Oilers

These valve covers are fabricated aluminum welded to a one-piece billet rail that is machined to ensure a precision flat surface for superior sealing.

Moroso Coolant Tank for Subaru Impreza & WRX/STI

This tank is a direct bolt-in replacement for the stock plastic tank.

Moroso Ford 5.0 Coyote & 5.2 Voodoo Mustang Race Baffled Oil Pans

These 7.5 quart capacity oil pans are available are in steel or aluminum.

SBC External Single Stage Oil Pump from Moroso

By driving the V-band clamp attached vacuum pump off the back of the oil pump this creates a compact weight saving design with one belt only being utilized.