7CleanCsts.doc
So it’s important to remember when deciding on a specific approach to cleaning to strive for cleaning effectiveness, while at the same time, staying in compliance with Environmental Protection Agency (EPA) and Occupational Safety and Health Administration (OSHA) regulations. In order for a machine shop to have a positive return on investment, cleaning systems and
Machine Shop Market Profile
As is generally already known, the machineshop/custom engine rebuilder market struggled in 1996 to keeppace with production numbers generated in 1995. Many shop ownerstold us that demand was flat for machine shop services and/orrebuilt engines during 1996. Verification of these shop owners’ commentswas generated in our annual survey of the membership of the AutomotiveEngine Rebuilders
Getting A “Good Seat” : The Growth In The Valve Seat Insert Market
The growth in the valve seat insert market can be traced back to the early 1970s when the switch to unleaded fuel took place. Most of the engines in use or that were in core or inventory storage had to have replacement seats inserted in the exhaust side to prevent valve seat recession that occurred when the engines were run
Forklifts
Engine rebuilders often classify themselves as an automotive (car and light truck), and/or medium duty/heavy-duty diesel or industrial rebuilder, and usually primarily stay in one market or the other. Some cross the line and do business in both markets, but most tend to stay in familiar territory where they’re comfortable. Yet rebuilding forklift engines is
Perspective On Using CBN Versus Polycrystalline Diamond (PCD) Cutters
In your June Shop Line you offered Jerry Lawson’s of DCM Tech, Inc., perspective on using CBN versus poly crystalline diamond (PCD) cutters. Have any other manufacturers voiced their opinions? In PERA’s May 1996 Current Concerns publication, Andy Rottler of Rottler Manufacturing made the following observations on CBN versus PCD cutters:Rottler says that due to
Letters: Test Data For Failing Rectifiers Requested
The article by Donald Yuhas, “Dissecting CS-130 Diode Failure,” in the May, 1996 issue of Automotive Rebuilder gave electrical rebuilders insights into the ways that diodes can fail. The author concluded that high “current pulse” technology is needed for successful screening-out of diodes that will likely fail in the vehicle.While I share that conclusion, the
Valve Guide Repair Options
One thing you can almost always count on when rebuilding a cylinder head is worn valve guides. The guides experience a lot of wear because of the constant friction between the guide and stem. To make matters worse, positive valve seals on late model engines prevent the guides from receiving much lubrication. Side forces on