Crankshafts and Bearings – Keeping the Relationship Strong
Today’s engines typically have very tight tolerances everywhere and the crankshaft bearings are no exception. The truer the crank is in its alignment with the mainline and cylinder bore, the tighter the tolerances can be. Bearings and mainline bores must be very precise because during operation the crankshaft is not actually straight: it is elastic.
Shop Financials
If someone owes you money you cannot collect, you have a bad debt. A business bad debt, generally, is one that comes from operating your business. A business can deduct its bad debts from gross income when figuring its taxable income. Business bad debts may be deducted in part or in full. Non-business bad debts
Thrust Bearing Failure
Thrust bearings are used to control end play in the crankshaft. End play is important because it limits the fore and aft movement of the crankshaft in the block. If an engine is assembled with too much end play in the crank, or if the thrust bearing fails, the forward movement of the crankshaft in
Back to Basics: Preventing Piston Problems
Burned pistons. Scuffed pistons. Cracked pistons. These are problems no customer wants to experience in an engine you’ve built. Warranty claims can kill your business, so here are some tips on how to prevent these and other common piston problems. First and foremost, if you’re custom building an engine that has already suffered some kind
The IC Engine Is Here For The Long Run
For 100 years, the internal combustion (IC) engine has dominated the automobile industry with its power and convenience. It has provided this country and the world a reliable and economical source for transportation and has given enjoyment to scores of hot rod, classic car and restoration enthusiasts, as well as endless excitement in amateur and
Hot Heads: Valve Bowl Porting…Boost Power And Profits
Valve bowl porting is a smart way for shops to boost power and profits. A few new tools and a little knowledge can score big with performance heads Many shops in the country are getting lots of calls and opportunities to do cylinder head porting work. Many shops are stock rebuild businesses that are afraid
Cylinder Bore Honing: Main Objective When Refinishing The Cylinders
When an engine is rebuilt, the cylinders usuallyneed attention. Wear tends to create taper in the upper part ofthe cylinder that can reduce ring sealing and increase blowbyand oil consumption if not removed. The cylinder may also be outof round, scored or have other damage that requires correctingbefore a new set of rings will seal
The Nitty Gritty On Small Parts Cleaning: Many Ways To Clean Small Engine Parts
Tom Nichols, CEO and president of AutomotiveMachine & Supply, Inc., Fort Worth, TX, said availabilityis most often the key to why his shop cleans and reuses smallparts. Nichols said each day his shop cleans and reuses many smallparts, including valve locks, shims, springs, retainers, rockerarm assemblies, cam bore caps, nuts, bolts, etc. "Becausewe only
Ensuring Bearing Life: Crankshaft Bearings Are Always Replaced When Rebuilding An Engine
Crankshaft bearings are always replaced when rebuilding an engine because they’re a wear component. Heat, pressure, chemical attack, abrasion and loss of lubrication can all contribute to deterioration of the bearings. Consequently, when an engine is rebuilt new bearings are always installed. “Reading” the old bearings can reveal a great deal about conditions that may
What Is The Recommended Surface Finish
Shop Line, Automotive Rebuilder, July 1996 Q A In the Production Engine Remanufacturers Association’s (PERA) May 1996 edition of Current Concerns, Ed Keibler of Sunnen Products Co., St. Louis, MO, says that the typical Ra finish on cast iron should be 60 to 110 Ra. On aluminum cylinder heads it is much smoother – typically