John Edwards at Costa Mesa R&D is building a Toyota 2JGE engine for a land speed attempt. The client purchased one-piece lifters and a couple of them were slightly oversize by about .0015˝, so they had to micropolish them so that they would fit in the lifter bore. Watch as Edwards uses a simple shop-built tool to mount the lifters in the lathe.
Engine Builder Staff
Latest posts by Engine Builder Staff (see all)
- Burton Center for Arts and Technology Wins Hot Rodders of Tomorrow Engine Challenge - Dec 19, 2014
- TI Automotive High-Performance Fuel Systems Catalog - Dec 19, 2014
- Magnum Performance Gaskets Announces New Catalog - Dec 18, 2014