Coolant Leak Caution on 1995-2003 Nissan 3.0L, 3.5L Engines - Engine Builder Magazine

Coolant Leak Caution on 1995-2003 Nissan 3.0L, 3.5L Engines

CONDITION: A severe coolant leak from the water pump’s weep holes causes the coolant to destroy the pump’s bearing as well as leak into the engine’s oiling system. Catastrophic engine failure can result.

CAUSE:  This engine’s water pump is buried beneath the timing cover since it is internally driven off the engine’s timing chain. Since the front of the pump has direct contact with the engine’s oiling system, the weep holes have been rerouted.  Leaking coolant is channeled back through the pump and into the engine block.  Therefore, if the water pump seal fails, the noticeable leaks will occur as coolant exits the left side of the engine block just below the thermostat housing.

CORRECTION: Be aware of the potential leak points and do not ignore the signs of a leak. It also is recommended that the water pump be changed whenever servicing the timing chain and/or internal timing components.

Use replacement water pump AIRTEX P/N AW9309.

–Courtesy of ASC Industries

You May Also Like

Factors of Crankshaft Selection

From the high-performance powerplants propelling Top Fuel dragsters to the subdued engines found in family sedans and grocery getters, each crank must be tailored to, and appropriate for, its specific application.

We know a crankshaft plays a critical role in an engine’s performance, converting reciprocating motion into rotary motion while serving as the backbone of the entire system. It must be strong enough to withstand the continuous pounding of rods and pistons, yet possess enough elasticity to absorb vibrations and flex, albeit slightly, when needed.

Shop Solutions March 2024

I always keep a pair of needle nose pliers and a small, straight screwdriver in my blast cabinet to hold small parts when blasting.

Degreeing the Camshaft and Checking Valve-to-Piston Clearance

Jeff McCord of LinCo Diesel Performance walks you through degreeing a camshaft and checking valve-to-piston clearance.

Designing a Better LS Engine

After a customer wanted a Steve Morris Engines’ SMX in an LS version, Steve saw the upside and potential in the market, and a challenge to build a better LS.

Other Posts

The Importance of a Good Valve Job

The valve job ensures the mating surfaces of the valves and the seats properly control the air/fuel mixture.

Getting Better Cylinder Head Airflow

When it comes to improving horsepower and rpm, airflow has a lot to do with it, and it seems the job is one that’s never finished.

Horsepower and Head Gasket Technology

Head gaskets have one of the toughest job in an engine, and now we’re pushing them harder than ever, making it easier to expose the slightest weakness.

Inside the Development of Frankenstein’s F-Series LS Cylinder Heads

Right away, engine builders knew it was special.